CoolBot DIY WalkIn Cooler Installation Guide

Coolbot Instructions. CoolBot DIY WalkIn Cooler Installation Guide The CoolBot Pro uses 2 temperature sensors (ROOM and FINS), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up. Common questions about the CoolBot, A/Cs, Uses, humidity, winter use, etc

Common questions about the CoolBot, A/Cs, Uses, humidity, winter use, etc The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up.

CoolBot Pro with WiFi for DIY Walkin Coolers

Take the cable sensor coming from the CoolBot Pro port labeled "Fins" and gently insert just 1/4 inch (0.7 cm) of the TIP into the small gap Take the cable sensor coming from the CoolBot Pro port labeled "Fins" and gently insert just 1/4 inch (0.7 cm) of the TIP into the small gap The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up.

Do It Yourself Tutorials Build Your Own Walk in Cooler Using a. The provided Data Cable is specific to the CoolBot Pro/Jumper - standard phone cable will not work and may damage your CoolBot Pro/Jumper STEP 2 Connect the CoolBot Jumper to the CoolBot Pro using ONLY the provided silver/grey Data Cable

CoolBot Installation Guide YouTube. Page 13: Changing Settings On The Coolbot Pro CHANGING SETTINGS ON THE COOLBOT PRO The CoolBot will always remember all your last settings even if it has been unplugged for a long time. STEP 2 Mount the CoolBot on the wall next to the A/C's control panel side